Silvercrest SNM 33 C1 - Monogramming and Embroidering with Embroidery Hoop

US-EN 25
Sewing basics
Monogramming and embroidering with embroidery hoop*
Stitch Stitch width stitch length
1~5 0
Attach the embroidery and darning
plate
1. Remove the presser foot and the
presser foot holder.
2. Attach the embroidery and darning plate
(o).
3. Lower the two-step presser foot lifter
(18) before starting to sew.
4. Adjust the stitch width according to the
size of lettering or design.
Preparation for monogramming and
embroidering*
1. Draw the desired lettering or design on
the right side of the fabric with the use
of a water-soluble fabric marker.
2. Stretch the fabric between the
embroidery hoop as rmly as possible.
3. Place the fabric under the needle.Lower
the two-step presser foot lifter (18).
4. Turn the hand wheel (21) towards you
to bring up the lower thread through the
fabric. Sew a few securing stitches at
the starting point.
5. Hold the hoop with thumb and
forengers of both hands.
6. Coordinate the sewing speed and the
movement of hoop.
* The embroidery hoop is not supplied with the
machine.