Silvercrest SRW 2 A1 User Manual

11
SRW 2 A1
GB
IE
CY
Set-up location requirements
For safe and trouble-free operation of the device, the set-up location
must fulfil the following requirements:
■ The surfaces of furniture may possibly contain components that
could affect the device’s rubber pads and soften them.
If necessary place a cover under the device’s pads.
■ The mains power socket must be easily accessible so that the
power cable can be easily disconnected in an emergency.
Inserting batteries
By inserting two 1.5 V batteries (type R6/LR6/AA/Mignon) you
avoid losing the programmed time of day and alarm time in the
event of mains power loss. The batteries make sure that the internal
clock continues to run even during a power outage. The display
will then automatically show the correct time when mains power is
restored.
NOTE
► The display, radio, alarm clock and night light do not function in
emergency mode.
♦ Open the cover of the battery compartment
5
on the bottom of
the device.
♦ Insert two 1.5 V R6/LR6/AA/Mignon batteries (not supplied)
into the battery compartment
5
. Insert the batteries as shown
on the polarity diagram in the battery compartment
5
.
♦ Close the battery compartment
5
by replacing the cover and
clicking it into place.

Silvercrest SRW 2 A1 Specifications

General

Brand	Silvercrest
Model	SRW 2 A1
Category	Clock Radio
Language	English