Silvercrest SSW 400 A1 - Fitting and Removing Attachments

■ 8 │ GB
SSW 400 A1
Fitting/removing the attachments
WARNING! RISK OF INJURY!
► Do not insert the plug into the mains power socket until the appliance is
fully assembled.
► Take great care when handling the attachments -! They are
very sharp!
1) To fit an attachment - onto the drive shaft , push the shaft of
the attachment - onto the drive shaft  on the blender foot .
The two bulges on the drive shaft  should grip into the recesses on the
shaft of the attachment -:
2) Then push the attachment firmly onto the drive shaft  so that the attachment
- until you hear and feel it click into place.
NOTE
► The beating disc - is fitted onto the shaft at an angle. This is not a manu-
facturing error, but designed to whip air into liquids.