6
GB
~ Ensure that the power cable cannot be
trapped or crushed.
~ To pull the mains plug out of the wall
socket, always pull on the mains plug,
and never on the power cable.
~ Disconnect the mains plug from the wall
socket …
…after every use,
…if there is a fault,
…when you are not using the device,
…before you clean the device and
…during thunderstorms.
DANGER - Fire hazard
~ Never leave the device unattended
while it is plugged in.
~ Use the device on a stable, level and
heat-resistant surface.
~ Never cover the device when connect-
ed due to possible overheating and fire
hazard!
~ Do not use the device in the vicinity of
flammable materials or flammable gas-
es.
DANGER! Risk of injury
through burning
~ The welding wire becomes very hot dur-
ing operation. Do not touch the hot
welding wire.
~ Allow the device to cool down com-
pletely before you clean it or put it
away.
DANGER! Risk of injury
~ Ensure that you never vacuum your skin,
hair or clothing with the adapters.
DANGER caused by
insufficient hygiene
~ For a carefree enjoyment of your vacu-
um-sealed food, you should always
comply with the following hygiene tips:
- During the preparation and packag-
ing of the food make sure that the en-
tire equipment is perfectly clean.
- Clean the vacuum sealer and all de-
vices thoroughly after use.
- Perishable food should be cooled or
frozen immediately after sealing.
- After thawing or heating perishable
food, this must be consumed immedi-
ately.
WARNING! Risk of material damage
~ After the sealing and/or vacuuming
process, the device needs to cool down
for at least 80 seconds.
~ Only use special plastic film bags that
are suitable for use with vacuum sealers
/ bag sealers.
~ Never place the device on hot surfaces
(e.g. hot plates) or near to heat sources
or open fire.
~ Ensure that no liquid is sucked in during
the extraction of air.
~ The device is fitted with non-slip silicon
feet. Because furniture can be coated
with a wide variety of varnishes and
plastics, and treated with various care
products, the possibility cannot be ex-
cluded that some of these substances
have components that may attack and
soften the silicon feet. If necessary,
place a non-slip mat under the device.
~ Do not use any sharp or abrasive clean-
ing agents.