GB│IE│NI │ 7 ■
SWKD 2400 B2
Cable retainer
A cable retainer
is located on the base
of the appliance. This winder
allows you to adjust the length of the cable to your local requirements.
CAUTION – PROPERTY DAMAGE!
► Ensure that you always guide the cable through the corresponding gap in
the rear of the base
for the sake of stability.
NOTE
► Always wrap the power cable around the cable retainer
in a clockwise
direction. This reduces the length of the cable to a minimum, allowing you
to guide the cable through the gap in the base
(see fig. 1).
Fig. 1
IB_292034_SWKD2400B2_GB_IE_NI.indb 7 17.10.17 10:54
To Next Page
Loading...
