Silvercrest SWKD 2400 B2 - Filter Maintenance and Storage; Scale Filter Insert Care; Appliance Storage; Proper Storage Procedures

GB│IE│NI │ 13 ■
SWKD 2400 B2
Inserting/removing the scale filter insert
The spout of the kettle is fitted with a scale filter insert which can become
clogged with particles or scale over time. To clean the scale filter insert
,
simply remove it from the appliance.
♦ Open the lid
.
♦ Grip the scale filter insert
by the tab and pull it out diagonally upwards
toward the rear.
♦ Clean the scale filter insert with a slightly moistened dishcloth under
running water.
♦ After cleaning, replace the scale filter insert in the appliance by inserting
it into the guide rails for the scale filter insert and gently pushing it down
until it clicks into place.
NOTE
► If scale deposits have solidified in the scale filter insert
, place the filter in
a water-vinegar solution with a ratio of 6:1 for a few hours. The scale de-
posits will dissolve. Rinse the scale filter insert
with plenty of fresh water.
► Alternatively, you can remove the scale filter holder by pushing down the
upper retaining collar in the pouring opening from the front and pulling
the scale filter holder to the rear. To reinsert the scale filter holder, push the
lower retaining collar onto the edge, press the top retaining holder lightly
downwards and allow it to click into the housing.
Storage
■ Allow the appliance cool down completely before putting it into storage.
■ Wind the power cable around the cable retainer
underneath the base
.
NOTE
► Always wrap the power cable around the cable retainer
in a clockwise
direction. This reduces the length of the cable to a minimum, allowing you
to guide the cable through the gap in the base .
■ Store the appliance in a dry location.
IB_292034_SWKD2400B2_GB_IE_NI.indb 13 17.10.17 10:54