Silvercrest SWKD 2400 B2 - Water Heating Operations; Standard Boiling Water Process; Custom Temperature Control; Setting Specific Water Temperatures

■ 10 │ GB│IE│NI
SWKD 2400 B2
Boiling water
♦ Lift the jug off the base to fill it with water.
♦ Open the lid
by pressing the release button .
♦ Fill the kettle
no further than the MAX mark, so that boiling water cannot
spill out. When filling, hold the jug
upright. This allows you to read the
scale correctly.
♦ Close the lid
by pushing it down until it clicks into place.
♦ Place the filled jug
onto the base .
♦ Insert the plug into a mains power socket. The button lights up and
the current temperature of the water contained in the jug is then shown on
the display .
♦ Press the button to start the heating process. The display indicator
flashes,  (°C) is displayed by default. The button will light up
during the heating process.
♦ As soon as the water reaches the set temperature, you will hear a beep and
the heating process will stops. The display indicator and all buttons go
out after about 30 seconds.
WARNING – RISK OF INJURY!
► Do not open the lid
while the water is boiling or extremely hot.
There is a risk of scalding.
NOTE
► You can stop the heating process at any time by pressing the
button
or removing the jug from the
base . The display indicator and all
buttons go out.
► When you replace the jug
on the base , the heating process will not
be resumed until you press the
button again.
Heating the water to a specific temperature
The appliance has a setting allowing you to specify your desired water temper-
ature. You can set the target temperature between 40°C and 100°C in 5°C
stages.
♦ If the appliance is deactivated, press the
button
.
The current tempera-
ture of the water contained in the jug is then shown in the display
.
♦ Press one of the arrow keys
to choose the desired target temperature.
The heating process starts automatically. You can also change the tempera-
ture during the heating process.
♦ As soon as the water reaches the set temperature, you will hear a beep and
the heating process will stops. The display indicator and all buttons go
out after about 30 seconds.
IB_292034_SWKD2400B2_GB_IE_NI.indb 10 17.10.17 10:54