Silvercrest SWKD 2400 B2 - Control Panel and Power Connection; Control Panel Layout and Functions; Initial Appliance Setup; Connecting to the Power Supply

■ 8 │ GB│IE│NI
SWKD 2400 B2
Control panel
The control panel is made up of the following components:
Display: temperature display
Arrow buttons ▼ ▲: increase/decrease target temperature
button: switch appliance on/off , start/cancel heating process
button: switch keep-warm functionon/off
Fig. 2
Connecting the power supply
CAUTION – PROPERTY DAMAGE!
► Before connecting the appliance, compare the connection data of the
appliance (voltage and frequency) on the rating plate with that of your
electrical supply. This data must correspond in order to prevent damage to
the appliance.
♦ Unwind the power cable from the cable retainer
.
♦ Guide the power cable through the gap in the back of the base
.
♦ Insert the plug into a mains power socket. Insert the plug into a mains power
socket. If the jug
is placed on the base , the button lights up
and the current temperature of any water contained in the jug is then shown
on the display . The appliance is now in standby mode for around 30
seconds.
Before fi rst use
Before starting to use the appliance, ensure that the appliance, the plug and the
cable are in a fault-free condition and that all packaging materials are removed
from the appliance.
Before preparing water for consumption for the fi rst time, you need to clean the
jug
. Proceed as follows:
♦ Open the lid
by pressing the release button .
IB_292034_SWKD2400B2_GB_IE_NI.indb 8 17.10.17 10:54