Silvercrest WK 8 A2 - Inserting Batteries and Power Supply

WK 8 A2
■ 14
│
GB
│
IE
│
NI
Opening and closing the camera
The control buttons, connections and the battery compartment are
inside the camera.
♦ Undo both of the side locking clamps
12
to open the camera.
♦ To close the camera, hook the metal bars of the locking clamps
into the brackets and then press the plastic latch downwards.
There is a locking eyelet
4
between the two locking clamps with
which you can securely close the camera with the help of a padlock.
Inserting the batteries/connecting power supply
♦ To insert batteries
35
in the device, open the camera.
♦ Now, press the latch on the underside of the battery compartment
cover down a little way and lift the battery compartment cover off.
♦ Insert 4 or 8 x 1.5V AA/Mignon/LR6 batteries into the battery
compartment
11
. While doing so, please note the stated polarity
and ensure that the batteries are placed on the black textile tape
as shown in the figure. The textile tape makes removing the bat-
teries easier.
AA
A
A
AA
AA
A
A
AA
A
A
AA
NOTICE
► When using 4 batteries, these can either all be inserted in the
upper part or all in the lower part of the battery compartment.
Other combinations are not possible.