WK 8 A2
■ 38
│
GB
│
IE
│
NI
Malfunction Possible cause Remedy
The images are
overexposed.
The camera is pointing
at reflective objects.
Change the alignment of
the camera.
Direct sunlight may be
shining onto the device,
possibly only at certain
times of the day (pay
attention to the position
of the sun).
The captures
contain noise
(artefacts).
The speed rating of the
card is too low or the
card is defective.
Use a new card with
a speed rating of 10
or higher and format it
before use.
There are no
pictures on the
memory card
even though
the settings of
the camera are
correct.
You have installed the
camera such that no
wildlife can enter the
detection range of the
motion sensors.
Change the installation
location of the camera.
The camera is
making too many
unwanted record-
ings.
The camera may be
being triggered by
branches moving in the
wind.
Change the installation
location and/or the align-
ment of the camera.
The sensitivity of the
motion sensors may be
set too high.
Reduce the sensitivity of
the motion sensors.
NOTICE
► If you are unable to resolve the problem by taking any of the
aforementioned steps, please contact the Customer Service
department.
To Next Page
Loading...
