Silvercrest XL SLXL 20 A1 - Battery Charging Procedure; Charging the Integrated Battery

■ 8
│
GB
│
IE
│
NI
SLXL 20 A1
Charging the battery
CAUTION
► Charge the speaker only in dry interior rooms.
► Due to the high power consumption, the speaker must be charged using a
USB mains adapter. Do not charge the speaker from the USB port of a PC
or notebook.
► Use only a USB mains adapter with an output voltage of 5V and an output
current of at least 2.1A to charge the speaker.
► Use only the supplied charging cable
to charge the speaker!
► Always disconnect the charging cable
when charging is complete!
Before using the speaker, the integrated battery must be completely charged.
♦ Open the protective cover
.
♦ Connect the USB type A connector on the charger cable
to a suitable
USB mains adapter (not supplied).
♦ Connect the micro-USB plug on the charger cable
to the micro-USB
charging port on the speaker.
A rough estimate of the charge level is shown during charging by means of the
charge level LEDs
:
LED display Charge level
One LED is flashing < 25 %
One LED is on, the second LED is flashing 25 ‒ 49 %
Two LEDs are on, the third LED is flashing 50 ‒ 74 %
Three LEDs are on, the fourth LED is flashing 75 ‒ 97 %
All LEDs are on 98 ‒ 100 %
♦ When charging is complete, remove the charging cable
from the speaker
and close the protective cover .
NOTE
► The operating/charging LED
lights up orange during charging. When
the battery is fully charged, the operating/charging LED switches off.
► When the battery is fully charged, you can play back music for around
9hours at a medium volume. The playback time may vary depending on
usage.
► When the battery status is low, you will hear a single beep around
30minutes before the battery is exhausted. The operating/charging LED
flashes orange every 15 seconds. When the battery is exhausted, the
speaker turns off automatically.