GB
│
IE
│
NI
│
15 ■
SLXL 20 A1
Charging mobile devices with the speaker
♦ Connect the micro-USB plug on the charger cable to the micro-USB
charging port on the mobile device to be charged.
♦ Connect the USB type A connector on the charger cable
to the USB type
A socket on the speaker.
♦ Switch on the speaker. The charging process begins automatically.
♦ If charging does not start automatically, press the
button briefly to start
the charging process.
NOTE
► Alternatively, you can also use the original charging cable (USB cable)
provided by the respective device manufacturer.
♦ During charging, the current charge level of the speaker is shown via the
charge level LEDs
(see table in the section Checking the charge level).
♦ To stop charging, disconnect the charging cable from the mobile device and
the speaker.
Troubleshooting
The speaker cannot be paired with a compatible Bluetooth
®
device
♦ Make sure that the Bluetooth
®
function is activated on the Bluetooth
®
device. When a device is connected via a 3.5 mm jack cable , the
Bluetooth
®
function is deactivated.
♦ Make sure that the speaker is switched on.
♦ If you use several Bluetooth
®
devices, ensure that any previous connection
is disconnected. There may be a previously paired Bluetooth
®
device in
range.
♦ Make sure that the speaker is no more than 10 metres from the Bluetooth
®
device and that no obstacles or electronic devices are placed between them.
You cannot switch on the speaker
♦ The integrated battery in the speaker is empty. Recharge the battery.
You cannot use all of the described functions
♦ This may be down to your Bluetooth
®
device and its current software.
Try updating the software or using a different Bluetooth
®
device.
To Next Page
Loading...
