Silvercrest XL SLXL 20 A1 - Speaker Handling and Operation; Bluetooth Device Pairing

■ 10
│
GB
│
IE
│
NI
SLXL 20 A1
Handling and operation
Pairing the speaker with a Bluetooth
®
device
NOTE
► If you want to pair the loudspeaker with a Bluetooth
®
device, the 3.5 mm
jack socket may not be occupied.
When using the device for the first time, proceed as follows:
♦ Ensure that the speaker is switched off and the Bluetooth
®
device is
switched on.
♦ Set the Bluetooth
®
device so that it scans for other Bluetooth
®
devices.
A detailed description of how to do this can be found in the operating
instructions for your Bluetooth
®
device.
♦ Press and hold the
button for about 3 seconds to turn the speaker on.
You will immediately hear a rising sequence of beeps and the operating/
charging LED flashes blue and orange twice. Then you will hear a beep
and the operating/charging LED flashes alternatively orange und blue.
The Bluetooth
®
function is now activated automatically.
♦ Select the entry
from the list of found devices on your
Blue tooth
®
device and, if required, enter the code to connect the two
devices. You will hear a beep and the operating/charging LED flashes
blue every 3 seconds once the connection has been successfully established.
♦ Start playback on the Bluetooth
®
device.
♦ Press and hold the
button for about 3 seconds to turn the speaker off
and deactivate the Bluetooth
®
function. You will hear a descending series
of beeps. The operating/charging LED flashes blue and orange twice
simultaneously and then goes out.