SilverStone RM44 User Manual

www.silverstonetek.com
User manual
x4
1. Remove 4 screws from expansion card retainer 2. Expansion card retainer position shift (It is recommended to avoid the position
of the expansion card connectors, and make sure the length of the PSU will not
interfere.)
Position 1
Position 3
Position 2
Position 4
3. Install 2 x 3.5" HDD on the expansion card retainer 4. Install 3 x 2.5" SSD on the expansion card retainer
5. Install 2.5" drives on 2.5" trays. 1. Height limitation with expansion card clip buckle installed
113mm
Graphics Card
4. Removing expansion card clip buckle
Press and push
Pull up
1
2
5. Adjust the position of the expansion card retainer according to the required
height of the interface card, then tighten the screw
loosen
tighten
2. Height limitation with expansion card clip buckle removed
139mm
Graphics Card
3. Height limitation with expansion card retainer removed
Graphics Card
154mm
1. Install Nvidia 30 series graphics cards 2. Install Nvidia 30 series graphics cards bracket (slightly tighten the screws, and
reserve space for the bracket to slide left and right)

SilverStone RM44 Specifications

General

Model	RM44
Form Factor	4U
Expansion Slots	7
Type	Rackmount
Material	Steel
Motherboard Support	Micro-ATX, ATX
Cooling System	Front: 120mm x 3, Rear: 80mm x 2
Front I/O Ports	Audio x 1 MIC x 1
Power Supply Support	Standard PS2 (ATX)

Summary

Hard drives and expansion card retainer installation

Install 3.5 inch HDDs on retainer

Mount two 3.5-inch hard drives onto the expansion card retainer.

Install 2.5 inch SSDs on retainer

Mount three 2.5-inch SSDs onto the expansion card retainer.

Expansion card height limitation

Height limit with clip buckle installed

Specifies the maximum expansion card height with the clip buckle attached.

Height limit with retainer removed

Specifies the maximum expansion card height with the retainer detached.

Nvidia 30 series graphics card brackets installation

Install Nvidia 30 series graphics cards

Guide for installing Nvidia 30 series graphics cards into the chassis.

Vertical orientation installation

Remove L-shaped handle bar brackets

Detach the L-shaped handle bar brackets from both sides of the chassis.

Install handle bar to bracket

Attach the handle bar to its corresponding flat bracket.

Install Mini Redundant PSU

Remove ATX PSU bracket

Detach the ATX PSU bracket to prepare for mini redundant PSU installation.

Install Mini Redundant PSU

Mount the mini redundant power supply unit into the chassis.

Component restrictions

CPU cooler height limits

Maximum CPU cooler height with and without the expansion card retainer.

Graphics card length limit

Maximum length for graphics cards, front panel fans, and radiators.