How to fix Simer Water Pump when motor will not run?
If your Simer Water Pump motor won't run, first, disconnect the power. Then, check the fuse and replace it if it's blown, or reset the circuit breaker if it has tripped. Also, ensure the power cord is properly plugged into a 115 Volt grounded outlet.
What to do if Simer ACE IN THE HOLE Water Pump motor runs but no water is delivered?
If your Simer Water Pump motor runs but no water is delivered, try the following: * Re-prime the pump according to the instructions. * Check and clean the water filter, ensuring it's installed on the discharge side of the pump. Remember to stop the pump and shut off the water before changing the filter cartridge. * Open the discharge valve if it's closed. * Ensure you are using a pipe size that matches the suction and discharge ports on the pump. * Clean the impeller, and thaw any frozen pipes.
Why Simer ACE IN THE HOLE motor runs hot and overload kicks off?
If your Simer Water Pump motor runs hot and the overload kicks off, or if the motor only hums, check the voltage being supplied to the pump. Additionally, ensure that the impeller moves freely and is not clogged.
What to do if Simer ACE IN THE HOLE Water Pump starts, but then does not stop when no water is being used?
If your Simer Water Pump starts but doesn't stop when no water is being used, verify that there are no leaks in the system. Confirm the system, with the main city valve closed and the pump unplugged, will hold pressure without dropping, indicating a water leak. Also, ensure the pump is mounted on a solid, level, horizontal surface. Finally, inspect the discharge valve of the controller for any debris; the valve should be seated in the down position when the discharge pipe is removed.
Why Simer Water Pump does not deliver water to full capacity?
If your Simer Water Pump does not deliver water to full capacity, replace any corroded pipes with plastic or new steel pipes. Ensure the piping size matches the suction and discharge ports on the pump. Enlarge the inlet pipe and check the well pump system to ensure the pump is receiving enough water. Verify that the outlet voltage is at 115 Volts.
General| Brand | Simer |
|---|---|
| Model | ACE IN THE HOLE Series |
| Category | Water Pump |
| Language | English |
To Next Page
