To Next Page
A
Anne PerkinsAug 11, 2025
What to do if Simer Water Pump doesn't deliver water to full capacity?
- Llaura71Aug 11, 2025
If your Simer Water Pump isn't delivering water to its full capacity, it could be because the water source is deeper than estimated, requiring a deep well jet if it's more than 25’ (7.6M) deep. Another cause might be corroded or limed steel piping, creating excess friction; replace it with plastic pipe if possible, or new steel pipe. Insufficient pipe size can also restrict water flow, so re-pipe using the correct size for the suction and discharge ports on the pump. Finally, the pump might not be getting enough water, in which case you should add additional well points.
General
