EasyManua.ls Logo

Simer 2305-04 - User Manual

Simer 2305-04
16 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
OWNER’S MANUAL
Submersible Utility Pumps
NOTICE D’UTILISATION
Pompe submersible
à usage général
MANUAL DEL USUARIO
Bomba sumergible
de uso general
Installation/Operation/Parts
For further operating, installation,
or maintenance assistance:
Call 800-468-7867
English .............................. Pages 2-6
Installation/Fonctionnement/Pièces
Pour plus de renseignements
concernant l’utilisation,
l’installation ou l’entretien,
Composer le
(800) 468-7867
Français ....................... Pages 7-11
Instalación/Operación/Piezas
Para mayor información sobre el
funcionamiento, instalación o
mantenimiento de la bomba:
Llame al 800-468-7867
Español ..................... Paginas 12-16
©2018 SIM861 (02/08/18)
5923 0109
2300-04, 2305-04, 2310-04, 2355-04
293 Wright Street, Delavan, WI 53115
Phone: 800-468-7867
Fax: 800-390-5351
www.simerpump.com

Table of Contents

Questions and Answers

  • J
    Jennifer RogersAug 7, 2025
    Why won't my Simer 2305-04 Water Pump start?
    • J
      John AustinAug 7, 2025
      If your Simer Water Pump won't start, first ensure it's properly plugged into a functioning outlet. Check the fuse; if it's blown, replace it with one of the correct size, or reset the breaker. Low voltage can also be a culprit; if the voltage is below the recommended minimum, inspect the wiring from the main switch. If the wiring is adequate, contact your power company. If none of these steps work, the motor may be defective, requiring pump replacement.
  • U
    utorresAug 20, 2025
    What to do if Simer 2305-04 runs but no water?
    • J
      jamesmasonAug 20, 2025
      If your Simer Water Pump is running but not delivering water, there might be a restriction in the discharge pipe due to an obstacle or ice. Remove the pump and thoroughly clean both the pump and the piping. Also, a restricted intake could be the cause; remove the pump and clean the intake screen. Low line voltage can also cause this issue; if the voltage is under the recommended minimum, check the wiring from the main switch. If the wiring is okay, contact the power company. A worn or plugged impeller may also be the reason, requiring pump replacement. Finally, check the anti-airlock hole and clean it out before restarting the pump.

Summary

Safety and General Information

Important Safety Instructions

Crucial safety instructions and warnings for installation, operation, and maintenance.

California Proposition 65 Warning

Warning about chemicals known to cause cancer and birth defects in California.

Specifications

Technical details including power supply, temperature, discharge, and adapter.

Installation and Operation

Installation Guide

Step-by-step guide for setting up the pump, including surface preparation and piping.

Pump Operation

Instructions for running the pump, including lubrication and safety during operation.

Operational Issues and Troubleshooting

Airlock Prevention and Resolution

Explanation and troubleshooting for airlocks, including the anti-airlock hole.

Troubleshooting Common Problems

Common problems, their probable causes, and corrective actions for the pump.

Repair Parts and Warranty Information

Repair Parts Identification

Diagram and list of replacement parts for Simer pumps.

Limited Warranty Details

Details the warranty period, terms, conditions, and limitations for Simer products.

General Warranty Terms

Explains warranty exclusions, purchaser's remedies, and liability limitations.

Simer 2305-04 Specifications

General IconGeneral
BrandSimer
Model2305-04
CategoryWater Pump
LanguageEnglish

Related product manuals