To Next Page
R
robertsmithJul 28, 2025
Why won't my Simer Water Pump start or run?
- QqclarkJul 28, 2025
Your Simer Water Pump might not start due to several reasons. It could be a blown fuse or tripped circuit breaker, in which case you should replace the fuse with one of the correct size or reset the circuit breaker. Another cause might be low line voltage. Check the wiring size from the main switch. If it's still under the recommended minimum, contact your power company. Lastly, the motor itself could be defective, requiring you to replace the pump.
General
