15
www.SimmonsDrums.net
factory settings
To restore your settings to the factory default, do the following:
Turn off the power. Hold down the [+] and [-] buttons with one hand,
then turn the power on. This will reset your module to factory setup
and erase all your settings.
Setup functions.
Here you can adjust some of the global parameters to suit your
playing style.
Turn off the power.
Set-Up Mode:
Hold down [KIT] button, then turn the power on to enter setup
mode.
Sensitivity:
Press [TEMPO/TAP] button, use [+] or [-] buttons to set sensitivity.
Range: 001-008
Threshold:
Press [KIT] button, use [+] or [-] buttons to set threshold.
Range: 000-050
Velocity Curve:
Press [SONG] button, use [+] or [-] buttons to set velocity curve.
There are four velocity curves from which to choose:
Normal (NOR), Dynamic (DYN), EASY (ESY), and Fixed (FID).
Cross Talk:
Press [CLICK] button, use [+] or [-] buttons to set XTALK .
Range: 000-080
Saving Set-up Functions:
Press [REC/PLAY] buttons to save above settings.
Power saving option:
Your SD100KIT will automatically turn off after 30 minutes of
non-use. To switch the power saving mode on or off, hold down
the (KIT) button, then turn the power on to enter setup mode.
While in set up mode, press the (REC/PLAY) button and hold for
2 seconds. (Factory default is set to off).
SON = Power saving ON. SOF = Power saving OFF.
REC / PL AY KIT SONG
INC +
DEC
-
Hold down to
mute drum
REC / PL AY KIT SONG
VOICE START
Hold down to
mute drum
To Next Page
Loading...
Need help?
General
