19
KIT MODE - ADVANCED
EDITING A KIT
1. Press the KIT button.
2. Press the EDIT button to see the screen for the current sound
3. Strike a drum pad to view the Voice currently assigned
4. Press the EDIT button to move to the rst parameter to
be changed on the current sound. Press the EDIT button
repeatedly to step through all the available parameters that
can be changed on the voice.
5. Press the -/+ buttons to change the parameter
6. Press the SAVE button to save the assignment to a User Kit.
(See Saving a kit)
Parameter Denition Notes
EditSnd Drum assignment Press +/- to select a bank of
sounds, then press EDIT again to
cursor to the sound list.
Volume Drum volume Range is 0-32
Pitch Drum Pitch Range is -8 to +8
V-Pitch Velocity to pitch Range is 0, 0.25, 0.5, 0.75, 1 to 12.
Fractional amounts can reduce a
machine-gunning effect.
Decay Drum Decay time Range is 0 to -5. Reducing the
decay time makes the drum ring
out for a shorter time.
Pan Drum Pan Pan each drum from Left8 to
Center to Right8.
R.LVL Reverb Level The reverb send for each drum.
Range is 0 to 32.
C.LVL Chorus Level The chorus amount for each
drum. Range is 0 to 32.
Reverb Reverb Type The reverb type for this kit.
Options are: Hall 1/2, Room 1/2/3,
Stage 1/2, Plate, Delay, Echo, Off
Chorus Chorus Type The chorus type for this kit.
Options are: Chorus 1/2/3/4,
Feedback Echo, Flanger 1/2/3,
Short Delay, Delay Feedback,
Celeste 1/2/3
Factory Reset Factory Reset Resets this kit to the default
settings. See page 20, “Kit Reset”
To Next Page
Loading...
Need help?
General
