JH-711 Manual JH-711 Manual
The next time you turn on the SIMOLIO and your phone’s Bluetooth, it should
automatically reconnect to your phone. Alternatively you can tap the
“SIMOLIO" in the Bluetooth list of your phone to reconnect them.
Disconnecting Bluetooth
When the “SIMOLIO” is connected, Press MFB twice in quick succession,
you will hear a prompt tone, the Bluetooth will be disconnected with the red
and blue LEDs flashing alternately. Or you can disconnect the “SIMOLIO” on
your phone. Or just turn off the Bluetooth feature on your phone.
7. Connecting with a Bluetooth enabled TV
STEP 1: Make sure “SIMOLIO” is OFF.
STEP 2: Press and hold the MFB for about 4 seconds until the blue LED
flashing slowly, you will hear a prompt tone, after about 8-10s, the red and
Reconnecting Bluetooth
(3) If there is a phone call while you are listening to music, the phone call will
take precedence over the music, and after the call, it will automatically
return to the previous listening state.
Smart TV
07
08
08
8. Connecting with a Bluetooth enabled iPad/PC/ Laptop
Note: Due to Bluetooth compression and
decompression, a variable audio signal delay
will always exist. You may find that there is a
little bit of out of sync between the sound and
the picture. This is a common phenomenon
and exists across all Bluetooth devices.
STEP 1: Make sure “SIMOLIO” is OFF.
STEP 2: Press and hold the MFB for about 4
seconds until the blue LED flashing slowly, you
will hear a prompt tone, after about 8-10s, the red
and blue LEDs flash alternately and enter the
pairing mode.
STEP 3: Activate Bluetooth on your iPad/ PC/
Laptop and connect with “SIMOLIO”.
Fig 3
Fig 4
(2) You can check the battery power of your Bluetooth headset on your phone,
the premise is that the phone should support the power display function.
blue LEDs flash alternately and enter the pairing mode.
STEP 3: Take “SIMOLIO” close to your TV and enable your TV's Bluetooth
function from its System Settings Menu then select “SIMOLIO” to connect.
To Next Page
Loading...
