Simoniz VE08 - 10. Troubleshooting

15
10. troubleshootIng
Disconnect the device from the power source before making any
repairs.
Problem Cause Solution
The motor does
not start.
The On/O switch is
in the OFF position.
Turn the switch to
the ON position.
The power cord is
not plugged in.
Plug in the power
cord.
The extension cord is
too long.
The extension cord is
not the proper gauge.
The extension cord is
damaged.
Replace the
extension cord with
either a 25’ (7.6 m)
14/2 gauge cord or
a 50’ (15 m) 14/2
gauge cord.
The power outlet
does not supply
adequate power.
Try a dierent
outlet.
Tripped pressure
washer circuit
breaker.
Allow the device
to cool, and then
restart it.
The device does
not reach high
pressures.
The garden hose is
too small.
Replace it with a
1” (25 mm) or
5/8” (13 mm)
garden hose.
Water supply is
restricted.
Check the garden
hose for kinks, leaks
or blockage.
Not enough water
supply.
Open water source
fully.
The water inlet lter
is clogged.
Remove the lter
and rinse it with
warm water.
The power nozzle is
in the low-pressure
position.
Replace it with
the desired high-
pressure tip.
The pump is sucking
air.
Check if all hoses
and ttings are
airtight. Turn the
device OFF, and
purge the pump by
pulling the trigger
on the spray gun
until a steady ow
of water emerges
through the nozzle.
Problem Cause Solution
Output pressure
uctuates high
and low.
Not enough inlet
water supply.
Turn faucet on fully.
Check garden hose
for kinks, leaks or
blockage.
The pump is sucking
air.
Check if all hoses and
ttings are airtight.
Turn the device OFF,
and purge the pump
by pulling the trigger
on the spray gun
until a steady ow
of water emerges
through the nozzle.
The water inlet lter
is clogged.
Remove the lter
and rinse it with
warm water.
The discharge nozzle
is obstructed.
Blow out or remove
debris with a ne
needle.
Calcied gun, hose,
or power nozzle.
Run distilled
vinegar through the
detergent container.
Detergent is not
working.
Detergent container
is empty.
Add more detergent.
Detergent bottle
or suction tube not
properly connected.
Check connections.
Detergent is too
thick.
Dilute detergent.
The lter on the
detergent suction
tube is clogged.
Run warm water
through the lter to
remove build-up.
Damaged or clogged
detergent suction
tube.
Remove obstruction
or replace the
detergent suction
tube.
The discharge nozzle
is obstructed.
Blow out or remove
debris with a ne
needle.
Troubleshooting