To Next PageTo Next Page
Need help?Do you have a question about the Simoniz sI900 and is the answer not in the manual?
General| Brand | Simoniz |
|---|---|
| Model | sI900 |
| Category | Pressure Washer |
| Language | English |
Basic precautions: read instructions, avoid jets at people/animals, keep away from wiring, operate near children, stay alert, wear goggles, cold water only, no solvents, dry connections, avoid gas vapors, avoid unstable surfaces, check ice, never carry by cord, allow air circulation, trigger lock.
No flammable liquids/chemicals. Injection hazard. Use components rated >= 1900 PSI. Shut off power before servicing. Do not spray electrical apparatus. Protect portable water system against backflow.
Motor has overload protection that shuts it off if current is excessive or it overheats. Device resets automatically.
Product must be grounded. Improper connection risks electrocution. Check outlet grounding with a qualified electrician. Do not modify plug.
Cords not recommended; use only if plugged into GFCI. Use sufficient gauge, outdoor-rated, 3-wire cords. Do not use damaged cords. Keep cords dry.
Do not draw non-water liquids. Use cold water supply only. Hose must be at least 1/2" diameter. Flow rate must not fall below 2 GPM. Water temperature must not exceed 40°C (104°F).
Check power connection, extension cord gauge/condition, outlet power, and reset breaker.
Check hose diameter, water supply, inlet filter, and nozzle position. Ensure no air is being sucked.
Check inlet water supply, filter, nozzle obstruction, and calcification. Ensure hoses are airtight.
Check detergent level, connections, thickness, filter, and nozzle position.
Tighten fittings or insert a new rubber washer.
Check for broken o-rings or inserts; ensure nozzle is properly attached.
Check for air in the pump and ensure fittings are airtight.
Check for loose fittings or damaged water seals.
Check for damaged oil seals.
Verify supply voltage, residual pressure, and avoid extension cords.
