1.1 FCC Information
This equipment complies with Part 68 of the FCC rules and the requirements adopted by the ACTA. On the door of this equipment is a
label that contains, among other information, the following product identifier: US: 5QWAL01A2004. If requested, the number must be
provided to the telephone company.
In the event of equipment malfunction, all repairs should be performed by an authorized agent. It is the responsibility of users requiring
service to report the need for service to our company or to one of our authorized agents. Service can be arranged through our office at:
Simplex Products
6 Technology Park Drive
Westford, MA 01886 USA
+1-978-577-4000
The Ringer Equivalence Number (REN), which is 01 for the DACT installed in this fire alarm control unit, is used to determine the number of
devices that may be connected to a telephone line. Excessive RENs on a telephone line may result in the devices not ringing in response to
an incoming call. In most, but not all areas, the sum of RENs should not exceed five (5.0). To be certain of the number of devices that may
be connected to a line, as determined by the total number of RENs, contact the local telephone company. The REN is part of the product
identifier, which uses the format US:AAAEQ##TXXXX. The digits represented by ## are the REN without a decimal point (for example 01 is a
REN of 0.1)
If the DACT causes harm to the telephone network, the telephone company will notify you in advance that temporary discontinuance of
service may be required. But if advance notice is not practical, the telephone company will notify you as soon as possible. If your service is
discontinued, you will be advised of your right to file a complaint with the FCC.
The telephone company may make changes to its facilities, equipment, operations, or procedures that could affect the operation of the
equipment. If this happens the telephone company will provide advance notice in order for you to make the necessary modifications to
maintain uninterrupted service.
If trouble is experienced with the DACT, please contact Tyco Safety Products at the location identified above. If the equipment is causing
harm to the telephone network, the telephone company may request that you disconnect the equipment until the problem is resolved.
page 4 579-1402 Rev B
2004 Foundation Series Fire Alarm Control Unit Installation Guide
To Next Page
Loading...
