Simplex 2120 Multiplex - Digital Control Board with Supervision (562-445) and Digital Control Board Without Supervision (562-459)

DIGITAL CONTROL BOARD WITH SUPERVISION (5620445), AND
DIGITAL CONTROL BOARD WITHOUT SUPERVISION (562-459)
DIGITAL CONTROL BOARD WlTH SUPERVISION, 562-445
DIGITAL CONTROL BOARD WITHOUT SUPERVISION, 562-4
.
\\CA
A
1
SW1
SW2
m; H;
(562-445 ONLY)
ET digital control boards are referred to as daughter cards, just as the ET digital monitor boards are. And, like
the digital monitor boards, the ET digital control boards provide switch package SW1 to select an address for each
board in the ET. Set the switches on switch package SW1 on both boards as shown in the illustration above and
Table K.
TABLE K
C = CLOSED
0 = OPEN
You use switch package SW2 on the 562-445 digital control board to set the board’s associated control points
to be supervised or unsupervised. Set the switches on SW2 as shown in Table L.
TABLE L
I CONTROL POINT I IFSUPERVISED I IF UNSUPERVISED I
I
1
1 CLOSE SW2-1 I
OPEN SW2-1 I
I
2 1 CLOSE SW2-2 I
OPEN SW2-2 I
I
CLOSE SW2-3
I
OPEN SW2-3
I
4
I
CLOSE SW2-4
I
OPEN SW2-4
I
30
firealarmresources.com