BAUD RATE SELECTION
Jumper package Jl (Figure 1) is used to select three baud rates. Once the baud rate is selected, it will be
available for use by any controller or device in the system. Unless specified at order entry, the standard system
configuration will be:
COMMUNICATIONS = 4800 Baud (Jumper from Pin 1 to Pin 16)
LOCAL PRINTER = 1200 Baud (Jumper from Pin 5 to Pin 13)
REMOTE PORT = 300 Baud (Jumper from Pin 7 to Pin 11)
Jl
- BAUD 3
1
I BAUD 2
- BAUD 1
FIGURE 1 FIGURE 2
This jumper package will be factory-preset. The only time you need be concerned with it is when replacing a
defective CPU board. In this case, remove the pluggable jumper package from the defective board and install it
on your replacement board.
Switch package S2 (Figure 2) is used to notify the system of specific operating conditions. Switch settings and
their functions are given in Table A.
4
To Next Page
Loading...