6-2
Chapter 6 Optional Modules and Cards
Optional Modules and Cards, Continued
Alarm Relay Card The Alarm relay card (4007-9809) is used to provide common unsupervised control functions
or indications for devices. Each relay module has three circuits (alarm, trouble, and supervisory
signals). It is not available when a city circuit card is used.
For more information on alarm relay card, refer to manual 579-955.
TrueInsight
Service Gateway
The remote service gateway (4190-6104) sends data to a remote service monitoring facility to
detail troubles in the panel. When the data reaches the monitoring facility, a qualified
technician is notified via e-mail and can then begin diagnostic process remotely.
For more information on the remote service gateway, refer to manual 579-953.
Dual Class A
Isolator
The Dual Class A Isolator (DCAI) (4007-9804) card converts the Class B output of the IDNAC
SLC into two isolated Class A outputs.
For more information on the DCAI, refer to manual 579-1029.
Example of
Combinations
Figure 6-1, Figure 6-2, and Figure 6-3 are examples of some of the combinations that can be
made in a 4007ES with the available optional cards and modules.
Figure 6-1. Example 1
IDNet+ Loop
Expansion cards
Power Supply
Relay Module
Zone/Relay
Module
Zone/Relay
Module
DACT
Module
BLOCK E
BLOCK F
BLOCK J
BLOCK K
BLOCK C
BLOCK I
BLOCK G
BLOCK H
BLOCK D
To Next Page
Loading...
