Warnings and Cauons — 3
tion or by static electricity. Never disconnect the ground wire
while the load bank is in use.
• Wire gauge sizes of electrical wiring, cables, and cord sets
must be adequate to handle the maximum electrical current
(ampacity) to which they will be subjected.
• Before installing or servicing this (and related) equipment,
ensure that all power voltage supplies are completely turned
o at their source. Failure to do so can result in hazardous
and possibly fatal electrical shock.
• In case of accident caused by electric shock, immediately shut
down the source of electrical power. If this is not possible,
attempt to free the victim from the live conductor. AVOID
DIRECT CONTACT WITH THE VICTIM. Use a noncon-
ducting implement, such as a dry rope or board, to free the
victim from the live conductor. If the victim is unconscious,
apply rst aid and seek immediate medical attention.
• Never wear jewelry when working on this equipment. Jewel-
ry can conduct electricity resulting in electric shock or may
get caught in moving components causing injury.
• Keep a re extinguisher near the hardware at all times. Do
NOT use any carbon tetra-chloride type extinguisher. Its
fumes are toxic, and the liquid can deteriorate wiring insula-
tion. Keep the extinguisher properly charged and be familiar
with its use. If there are any questions pertaining to re extin-
guishers, please consult the local re department.
• e illustrations in this manual are examples only and may
dier from your load bank.
• Main Disconnect to be provided by installer, rated 600V
maximum, sized 150% maximum of rated current.
• Load Bank warranty is void if incorrectly cooled.
To Next Page
Loading...
