EasyManuals Logo

Simplicity 2690817 User Manual

Simplicity 2690817
36 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #13 background imageLoading...
Page #13 background image
13
Figure 2. Engaging the Parking Brake
Parking Brake Function
Applying the Parking Brake - To lock the parking
brake, release the ground speed pedals (A, Figure 2),
fully depress the brake pedal (B), pull UP on the parking
brake knob (C), and then release brake pedal.
Releasing the Parking Brake - To release the parking
brake, fully depress the brake pedal (B, Figure 2) and
push the parking brake knob (C) DOWN.
IMPORTANT NOTE: The tractor’s hydraulic attachment
lift will not work when the parking brake is engaged.
Automatic Controlled Traction
What is Automatic Controlled Traction?
Automatic Controlled Traction (ACT) is an exclusive
feature of our transmissions that provides improved
traction. ACT applies a preset amount of torque to both
rear wheels even if one starts slipping (a transmission
without ACT will lose traction completely if one rear
wheel starts slipping). This preset torque is just enough
to provide additional traction, and still allow the wheels to
turn at different speeds in a tight turn without damaging
the lawn.
A
B
C
What to Expect from Your ACT Tractor
For the most part, while using your tractor you will not
notice ACT working, and you will simply become
accustomed to increased traction an ACT transmission
provides.
Under certain circumstances the ACT system limit can
be exceeded, and one of the rear wheels may slip (for
instance if trying to turn up a hill while accelerating).
This is normal. If you start to lose traction, do not speed
up. Instead, slow to a stop, straighten the steering wheel,
and slowly accelerate. Stopping the tractor allows the
transmission to regain more traction.
12 Volt Power Outlet
(Select Models)
CAUTION
Avoid Injury. Safe operation requires your full
attention. Do not wear radio or music headphones
while operating machine.
The 12-volt accessory plug is located in the left side pod
(see Figure 1). It can be used to power small electronic
devices. The accessory must be rated at 9 amps or less.
NOTE: Operating a 12-volt accessory, especially with the
engine at idle, may cause battery discharge. When not
using the accessory plug it must be covered with the
rubber plug to prevent moisture from causing a short
circuit. Entrance of water into plug can cause a short
circuit.
FEATURES AND CONTROLS
Not for
Reproduction

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Simplicity 2690817 and is the answer not in the manual?

Simplicity 2690817 Specifications

General IconGeneral
BrandSimplicity
Model2690817
CategoryLawn Mower
LanguageEnglish

Related product manuals