Adjusting Mower Cutting Height
The cutting height is infinitely adjustable between
approximately 1” and 3-5/8” (2,5-9,2 cm).
Electric Height of Cut Models: The cutting height
adjustment switch (A, Figure 6) controls the mower
cutting height. This same switch also controls the spout
rotator motor when a snowthrower is installed. The
arrows on the switch correspond to the direction of
adjustment (UP arrow raises cutting height, RIGHT arrow
rotates the spout right, etc). When the adjustment
indicator has reached the end of its travel, release the
switch; holding the switch down will damage the motor.
Figure 6. Raising and Lowering Mower
B
DO NOT TOW TRACTOR
Towing the unit will cause transmission
damage. • Do not use another vehicle to
push or pull this unit. • Do not actuate the
transmission release valve lever while the
engine is running.
Figure 5. Transmission Release Lever and Fuel Tank
A
Pushing the Tractor by Hand
1. Disengage the PTO and turn the engine off.
2. Pull the transmission release lever (A, Figure 5) back
approximately 2-1/2” (6 cm) to lock into released
position.
3. The tractor can now be pushed by hand.
A
17
Attachment Lift Control
Manual Lift Models: The attachment lift lever (B, Figure
6) raises and lowers attachments that utilize the tractors
manual lift linkage. To lower an attachment: pull the lever
back slightly, depress the release button, and push the
lever forward until it locks in the lowered position. To
raise an attachment: push the lever forward slightly,
depress the release button, then pull the lever back until
it locks in the raised position.
OPERATION
To Next Page
Loading...
Need help?
General
