Mower Deck Washout Port
NOTE: The washout port allows you to connect a typical
garden hose to the trim side (L.H.) of the mower deck to
remove grass and debris from the underside. This
ensures proper and safe operation of the mower.
1. Place the lawn tractor on a smooth level surface.
Figure 10. Mower Deck Washout Port
B
A
WARNING
Before running the mower, make sure the hose is
properly connected and does not come into contact
with the blades. When the mower is running and the
blades are engaged, the person cleaning the mower
deck must be in the operator position, and there are
no bystanders. Failure to follow these precautions
may result in serious injury or death.
2. Attach the quick disconnect (A, Figure 10) to garden
hose (B) and connect to washout port (C) on mower
deck.
3. Turn the mower on and place in the highest cutting
position.
4. Run water to remove grass and debris from
underside of mower deck.
5. Turn the mower off.
6. Remove the garden hose and quick disconnect from
the washout port when completed.
C
Storage
Before you store your unit for the off-season, read the
Maintenance and Storage instructions in the Safety
Rules section, then perform the following steps:
• Disengage the PTO, set the parking brake, and
remove the key.
• Perform engine maintenance and storage measures
listed in the engine owner’s manual. This includes
draining the fuel system, or adding stabilizer to the
fuel (do not store a fueled unit in an enclosed
structure - see warning).
WARNING
Never store the unit (with fuel) in an enclosed,
poorly ventilated structure. Fuel vapors can
travel to an ignition source (such as a furnace,
water heater, etc.) and cause an explosion.
Fuel vapor is also toxic to humans and animals.
• Battery life will be increased if it is removed, put in a
cool, dry place and fully charged about once a month.
If the battery is left in the unit, disconnect the
negative cable.
Before starting the unit after it has been stored:
• Check all fluid levels. Check all maintenance items.
• Perform all recommended checks and procedures
found in the Engine Manual.
• Allow the engine to warm up for several minutes
before use.
19
OPERATION
To Next Page
Loading...
Need help?
General
