Simpson 460 4 Series - Page 15

7.
Introduction
Accuracy (from +15°C
to +35°C):
Sensitivity:
Full Range Step Response
(to rated accuracy):
Temperature Coefficient
(from 0°C to +55°C):
Overrange Capability:
(Maximum Common
Mode Voltage):
Resolution:
. Display:
Numerical Display:
Conversion Rate:
DC Polarity Selection:
Overrange Indication:
Analog Display:
. Power Requirement:
AC Operating (460A) or
Battery Charging (460D):
+(0.7% of reading +2 digits), except on
2000mA and 10A ranges, which are
+(1.5% of reading +2 digits)
100nA on 2004A range
5 seconds
+(0.05% of reading +0.1 digit)/°C
Linear to 500 counts beyond maximum
indication (except on 10A range, where
any indication greater than 1000 is an
overload)
. {Rated Circuit-to-Ground Voltage: A
1000 volts (DC plus peak AC) maximum
from any measuring terminal to power-
line (earth) ground terminal, except on
10A ranges, which is 50 volts maximum.
1 part in 2000
3% digit, 7-segment light-emitting-diode
(LED) type, with 0.43 inch high nu-
merals.
4 readings per second, nominal.
Automatic with “+” or “—” indication.
Automatic beyond 1999, with the “1”
digit blinking.
1% inch edgewise meter with both linear
and dB scale markings.
120 VAC or 240 VAC +10% (check
rear panel designation), 50-400 Hz, 10VA
nominal.
f
Per
ANSI
C-39.5-1974:
The
specified
voltage
with
respect
to
ground
which
may
be
safely
and
continuously
applied
to
the
circuits
of
an
instru-
ment.
1-6