11.Move the machine into its final position making sure
that the drain hose or inlet hoses do not kink.
12.If the washing machine has 4 rollers fitted, you will
need to twist the front two around to stop the
washing machine from moving when in use.
(See fig. 11)
13.1t is important that your washing machine stands
firm and level on the floor to ensure correct
operation.
Use a spirit level on the front and side panels of the
washing machine to check the levels, (See fig. 12).
The spirit level should be used close to the corners of
the washing machine for accuracy.
Adjust the legs up or down as required (See fig. 13).
If you do not have a spirit level, as a guide use the edge
of a door frame, cupboard or bench to check that the
washing machine is level.
Make sure the washing machine does not wobble.
fig. 13
NOTE: When the washing machine is placed in its final position, make sure the drain hose is above the join line
between the cabinet and the washing machine top panel as shown below.
So that you can properly understand the many features of your new washing machine, please take a few
minutes to read through the CARE & USE manual supplied with this washing machine.
SINGLE DRAIN HOSE INSTALLATION
Use
will
litres.
Part
your
Standpipe:
0336-001-726
Available
agents
centres.
not
No.
if the
trough
hold 70
from
or
parts
II
dealer,
I
,
777
---
,,
.,
,
-4.
c
E
g
0,
I
I
Extended
,-
z
i I
1
Floor Drain
41111
‘ir
.P.
411:1
)
fr
lin
;
.:
k
----
Syphon Break:__
Part
Number
7666-000-000
Available from
your
dealer,
agent or parts
centres.
To be fitted if
Floor , Drain
is
less
than
900mm high.
/7
0
„
0
_
/co) -y'
,...1
.s
i
,
=.,.
-:
'
Il
lo
Z.
FAILURE TO FOLLOW THESE INSTRUCTIONS COULD RESULT IN DAMAGE TO THE MACHINE
WHICH MAY NOT BE COVERED BY WARRANTY.
616-200-315(Rev 5/97)
To Previous Page
Loading...
