1. Install the wheels.
Slide the axle pin through the wheel, formed washer, frame and other formed washer. Slide
clip through the hole in the axle pin to secure the wheel in place. Repeats steps for the
second wheel.
2. Install the handle.
Place the handle onto the frame, depress the snap buttons and slide the handle assembly
onto the frame until the snap buttons snap into place locking the handle to the frame.
Page 5
UNPACKING
ASSEMBLY
Follow the steps outlined in this section to unpack and assemble your pressure washer.
If you have any questions regarding the unpacking or assembly of your pressure washer,
please have your model number and serial number ready, then contact customer support at
1-877-362-4271 or email cservice@fna-group.com.
1. Place the shipping carton on a solid, at surface.
2. Carefully cut the top of the carton open.
3. Carefully cut each corner of the carton from top to bottom.
4. Lay each side of the carton at on the ground.
5. Remove everything from the carton.
To Next Page
Loading...
