• Water testing (Optional)
To monitor
the performance of your SimPure
®
T1 Water Purification
, you will need a water meter that can test the impurities in water.
®
has a simple to use handheld TDS meter designed for this
ollow the Monthly Maintenance procedure before
:
STEP 1 – OPEN the gooseneck faucet tap and run about one quart (1
liter) to drain before sampling the water
STEP 2 – Rinse a clean cup or small container with the purified water
and disregard, refill container.
STEP 3 – Place the SimPure
®
TDS Meter in the
instruction to take a TDS reading
STEP 4 – Once you have a purified water reading, you should then test
the feedwater. Run some water from your standard cold sink water
tap into a clean cup or small container and test the TDS.
that you have a water quality reading from the feedwater and the
compare and see how well your water purification
eneral guide, the purified water TDS level should be >90% lower
than the incoming feedwater indicating
the system is working well;
, this does depend on feedwater quality, which can be
substantially different from one region to another.
• Replacing Consumables
It is important to maintain the filters and RO membrane to ensure
the
outlet water quality is a consistently high standard.
he life expectance of filters and replacement schedule is dependent on
water quality and water consumption.
normal situations
, we recommend users replace filters as per the
table below:
Replacement Consumables Cartridges
Replacement
Schedule
(months)
RSWF003Z
(Kit of 4 Cartridges)
Reverse Osmosis (RO)
for 75 GPD model*
Reverse Osmosis (RO)
for 100 GPD model*
*Note: Depending on your system type order either the 75 or 100 GPD.
SimPure
®
TDS Meter
Part Number:
RSTDS001_S8
To Next Page
Loading...
