SimPure T1 - Assemble the Components

Assemble the
Components
•
How to use the Quick-Connect (QC) fittings
The
SimPure
®
T1 Water Purification system uses quick-connect (QC)
fittings making the installation simple and easy.
•
How to release tube (or plug) from a quick-connect.
(1)
Remove the locking C-clip by sliding it out from under the quick-
connect fitting collet.
(2)
Push the collet down onto the fitting (closing the gap between the
collet and fitting) and hold.
(3)
While holding the collet down, gently pull tube (or plug) in the
opposite direction at the same time to release.
•
How to insert tube into a quick-connect.
(1)
Make sure the tube has a clean square cut with no bur present.
(2)
Push the tube firmly into the QC fitting, making sure it is located
correctly (you will feel the tube ‘jump’ into position as you push it
into the fitting). The tube is secure once it has traveled ⅜” (15mm)
into the fitting.
(3) Replace the locking C-clips to secure the QC fitting.
•
Gooseneck Faucet Assembly
SimPure
®
T1 RO water purification system comes with a Gooseneck
faucet
, which is used to dispense the purified water. There are two
methods
for installation:
Fixing to the Sink. Try to install the faucet
on the sink surround if possible; make sure
you
have clear access above and below, and
the outlet is over the sink. Us
ing a hammer
and
center punch mark the hole. Drill a pilot
hole
first, working up to ½” (12.5mm) drill
bit
. Insert the faucet through the hole and
secure
it.
Tip
: if you do need to drill the countertop,
especially for
granite, tile, or concrete,
professional help might be required.
Fixing to the Wall
. Use the included Faucet
mounting plate. Drill
suitable size holes in
the wall
for the supplied x3 self-tapping
screws and wall plug (V
) or use an
alternative fixing method as required.
11
12
⅜”
(15mm)
Gooseneck Faucet
Assembly (outlet)
Locknut
Gasket
‘C’ clip
Locked into position
‘C’ clip
Remove lock clip
Pull
Hold
Pull
Faucet adapter ¼ “