Read the entire manual thoroughly before beginning your installation.
Take note of the safety tips and f
ollow all steps to ensure your system is
before use. Installation needs to comply with state
and local laws and regulations
; you mus
t check and comply with all local
plumbing codes.
Warning: Massachusetts, USA, require installation by a
es not permit the use of saddle valves.
-CMR of the Commonwealth of Massachusetts)
tial hand tools are required to install the SimPure
®
T1 RO water
. An electric drill, drill bits up to ½” (12.5mm),
djustable wrench, tube cutters (or knife), cross-head screwdriver
, hammer, and center punch.
your Installation
SimPure
®
T1 Water Purifier can be installed under a sink or in a
remote location. Typical remote sites are a laundry room or utility room.
Review the location options below and determine where you are going
to install your system.
Option 1: Under-sink. The unit can be installed in a kitchen or
bathroom sink cabinet. A suitable drain point is required for drain
water from the Reverse Osmosis system.
Option 2: Remote Interior. The unit may also be installed in a
remote interior location away from the RO Faucet. You will need a
nearby feed water source and drain point connection.
Determine and check the size and position of items for proper
installation into the chosen space and remember to leave enough
space
around the system for changing filters and maintenance.
Need assistance? Contact SimPure!
Before starting the installation, Isolate the hot and
cold-water supply.
Temporarily place tank and filter assembly into
the planned location.
Check the positioning of items and space required for
the correct
installation. Ensure that tube
will reach each section and can be installed
without any
kinking.
®
T1 RO water purification system
a flat surface or fixed on the
the sink.
on the wall, please use the
x2 self-tapping screws and wall plug
(U) or an alternative fixing method suitable
to your installat
ion requirements.
To Next Page
Loading...
