SimPure Y5 - System Flushing; Installing New Filters; Dispensing Purified Water

9
10
System Flushing
Installing New Filters
If you are commissioning the system for the first time or have just replaced
the filter cartridges, please refill the feed tank and then Discard all the
water inside. Repeat this process for 5-10 times (6.6-13 gallons of
water) to ensure the system is adequately flushed before use.
Infrequent System Use
To ensure the freshness of the drinking water, flush the system once using
the following steps if the feed tank water has not been emptied/refilled for
more than Three days.
Step 01
Always start the System flush with a new
tank of potable (tap) water.
Remove the feed water tank, empty and fill
with clean, fresh potable (tap) water.
Step 02
Place a measuring jug or large container on
the drip tray and have a second container
ready to alternate as we need to flush the
feed water tank through the system.
Dispensing Purified Water
Step 01
Place a cup or glass on the drip tray of the
system under the dispense nozzle.
Step 02
Rotate the dial to light up the desired
dispense temperature of the purified water.
Example: Select Coffee.
Step 03
Push the dial once, and the system will
dispense a cup of purified water 8 fl oz.
(240ml) and then stop automatically. To
manually stop dispensing, simply push the
dial again.
Step 03
Turn the center dial clockwise more than 5 times
when hear two beeps, purified water will start
to flow from the outlet until the internal tank is
emptied. Repeat this method until the change
water indicator light starts flashing.
CONGRATULATIONS!
You have completed the installation!
THIS DEVICE CAN PRODUCE VERY HOT
WATER WITH A RISK OF SCALDING;
DO NOT CONSUME WATER UNTIL FLUSHING IS COMPLETE
KEEP CHILDREN AWAY FROM DANGER!