Cable layout
171
857-164342 / Rev.C
Rubber gasket
Metal washer
Cable gland body
Compression nut
Cabinet wall
Inner cable
Outer screen bend backwards
over the rubber gasket
Cable
Metal washer
(CD3685/093878)
Figure 14 Cable gland, type 1 (842-093878)
Additional type 2 (541-093642)
1 Mount the cable gland body, and tighten it with the nuts
on each side of the cabinet wall.
2 Slide the metal washers, the rubber gasket and the
compression nut onto the cable in the order indicated in
the figure.
→ Refer t o figure 15.
3 Bend the screen over the compression cone.
4 Push the compression conne, the washers and the rubber
sealing washer into the cable gland body.
5 Close the mounting nut.
6 Close and tighten the compression nut on the other side of
the cabinet wall.
To Next Page
Loading...
