Simrad EQ60 - Changing the Transmit Power; Setting Minimum and Maximum Depth

Simrad EQ60
42
857-164342 / Rev.C
To change the pulse length:
1 Position the cursor over the frequency information in the
Header view, and click the right mouse button.
-TheTransceiver Settings dialogue box opens.
2 Move the pulse length slider to the desired pulse length
value.
3 Click Ok.
A small value gives the best resolution, while larger values are
mostly used for navigation and fishing in deep waters.
Related topics
→ Header view, page 20
→ Transceiver Settings, page 114
Changing the transmit power
To change the transmit power:
1 Position the cursor over the frequency information in the
Header view, and click the right mouse button.
-TheTransceiver Settings dialogue box opens.
2 Move the transmit power slider to the desired value.
3 Click Ok.
Related topics
→ Header view, page 20
→ Transceiver Settings, page 114
Setting minimum and maximum depth
Setting the minimum and maximum depth controls where the
echo sounder will search for bottom lock.
Note Setting both M inimum Depth and Maximum Depth to 0 m will
turn off bottom detection.
1 Position the cursor over the depth information in the
Header view, and click the right
mouse button.
-TheBottom detector dialogue box opens.
2 Set minimum and maximum depth to the desired values.
3 Click Ok.