Simrad GO XSE Getting Started

Autopilot
If an AC12N, AC42N, SG05 or a NAC-1 autopilot computer is
connected to the system, autopilot functionality is available in the
system.
The system does not allow for more than one autopilot computer
on the network.
The display unit automatically detects the autopilot computer
available on the network and presents settings, configuration and
user options for the connected computer.
An Autopilot is designed to maintain an accurate course in various
sea conditions with minimal helm movements.
Safe operation with the autopilot
Warning: An autopilot is a useful navigational aid,
but DOES NOT replace a human navigator.
Warning: A physical standby button should be
available for the autopilot. The NAC-1 comes with a
standby button, compatible remote controllers with a
standby button can be used with the other autopilot
computers.
Activating the autopilot
You activate the autopilot from any panel by selecting the autopilot
tile in the Instrument bar, followed by selecting a mode in the
Autopilot Controller.
Switching from automatic mode to manual
steering
You switch the autopilot to STBY mode from any automatic
operation mode from the autopilot pop-up or the physical standby
button.
6
24
Autopilot | GO XSE Getting Started

Simrad GO XSE Specifications

General

GPS	Yes
Chartplotter	Yes
NMEA 2000	Yes
Wi-Fi	Yes
Bluetooth	Yes
Waterproof Rating	IPX7
Operating Voltage	12V DC
Sonar	Yes (built-in)
Cartography	C-MAP, Navionics
Mounting Type	Bracket or Flush Mount
Screen Size	7-inch, 9-inch
Screen Resolution	800 x 480 pixels