Simrad - RS12 Operation and Installation Instructions
21
Section 3 - Radio Setup Menu (RADIO SETUP)
3-1 Radio Setup Menu (RADIO SETUP)
The following options are available through the MENU key:
* Model dependant
Sections 1-3 and 1-4 explain how to navigate around the menu and enter, save and change
data.
3-2 Channel (UIC)
Note: UIC may not be available on all models.
Toggle between USA, International or Canadian channel banks. The selected channel bank is
displayed on the LCD along with the last used channel. All the channel charts are shown in
Appendix C.
RADIO SETUP
►UIC
CH NAME
RING VOLUM▼
UIC
►USA
INT’L
CANADA
Edit or delete channel names.
See Section 3-3.
Selects if the WX Alert scanning mode is ON (on) or OFF (off ).
See section 3-7.
Selects Priority Channel operation with Dual or Tri watch scanning.
See section 3-6.
Switch ON/OFF (on/off) the radio’s internal speakers.
See section 3-5.
Select NMEA protocol for communications between the VHF radio
and any other instruments.
See section 3-8.
Set the volume level of the beeps.
See section 3-4.
Set the volume level of the incoming call notification beeps.
See section 3-4.
Channel band.
See Section 3-2.
UIC *
CH NAME
RING VOLUME
KEY BEEP
INT SPEAKER
WATCH MODE *
WX ALERT *
COM PORT
GPS SOURCE
Select NMEA 0183 or NMEA 2000 source to receive GPS data
See section 3-9.
To Next Page
Loading...
Need help?
General
