Singer 201P - Darning and Embroidery; Preparation for Darning;Embroidery

DARNING AND EMBROIDERING
Fig. 28. Preparation for Darning or
Embroidery
30
Turn machine back on its hinges. Un-
screw the thumb screw P2, Fig. 28
out of the lower hole A in the crank
Q2 until the crank Q2 is released.
Move feed lifting crank Q2 downward
so that thumb screw P2 will enter
upper hole B. Insert thumb screw P2
in this hole and tighten firmly. The
feed is thus rendered inoperative and
will not interfere with the free move-
ment of the work. Bring machine for-
ward into place.
Move stitch regulating lever W, Fig.
20, page 18 to its neutral position in
the centre of slot at front of machine.
Remove presser foot and let down
presser bar lifter G, Fig. 19, page 17
to restore tension on needle thread
which is released when lifter is raised.
Draw up bobbin thread as instructed on
page 16.