Singer 20U - How to Sew a Seam

r
HOW TO SEW A SEAM
1. Set feed regulating dial for desired stitch length.
2. Raise take-up lever to its highest point and place
fabric under presser foot.
3. Position needle in fabric, lower presser foot and
stitch to end of seam.
4. To reinforce seam ends, press stitch reverse lever
down to its lowest position and backstitch.
5. With take-up lever at its highest point, raise presser
foot and remove fabric.
6. Cut threads on thread cutter at rear of presser bar.
Most fabrics need to be guided in front of the
presser foot only. Some fabrics, however, require support
while being stitched.
—- For filmy sheers, knits, tricots, etc., apply gentle
tension by holding seam in front and back of presser
foot.
17 -