r
NOTE:
Having made
the
above adjustments,
you
need
not
regulate
the
stitch width regulator when sewing
the
side stitches.
To sew the
bar
tack,
the
stitch width regulator must
be
turned
to the
previously
set
bar
tack
width
and
held
in
this
position
until
bar
tack
is
completed.
Side Stitching: Position needle
in
fabric
at
point
A,
lower
presser
foot
and
stitch
to
point
B.
Leave needle
in
fabric. Raise presser foot
and
pivot work
on
needle.
Lower foot
and
take
one
stitch
without
changing
width setting, bringing work
to
point
C.
Leave needle
in
fabric.
Bar
Tack:
Turn stitch width regulator
to
previously
set bar
tack
width
and
while
holding
the
stitch
width
regulator
in
this
position,
take approximately
6
stitches
to
complete tack. Leave needle
in
fabric
at
point
D.
Side
Stitching:
With
needle
in
fabric
at
point
D,
stitch
to
point
E.
Leave
needle
in
fabric.
Final
Bar
Tack:
Turn stitch width regulator
to bar
tack width
and
while holding
the
regulator
in
this position, duplicate
bar
tack
previously
made.
Leave
needle
in
fabric
at
point
F.
Fastening
Stitch: With needle
in
fabric,
set
stitch width regulator
for
straight stitching
and
back tack approximately
3
stitches
to
point
G.
Remove work, draw threads
to
wrong
side
and
trim.
Cut
opening
for
button with sharp scissors.
\
21
-
To Next Page
Loading...
