Singer 9022 - Replacing Presser Foot with Shank; Attaching Feed Cover

REPLACING PRESSER FOOT WITH SHANK
Presser feet with built-in shanks can be replaced as
follows:
• Turn machine off.
• Raise needle and presser foot.
• Loosen presser foot screw (1) and remove presser
foot with shank (2), guiding it toward you and to the
right.
• To replace presser foot with shank, hook shank
around the presser bar and tighten presser foot
screw.
ATTACHING FEED COVER (F)
The feed cover keeps the feed from moving the fabric.
• Raise needle and presser foot.
• Open slide plate.
• Slide feed cover on top of needle plate, pressing tabs
(1) and (2) into holes.
• Close slide plate.
• To remove, open slide plate and lift front edge of
cover; pull it away.
12