Singer 9022 - Getting Ready to Sew; Connecting and Running the Machine

SECTION 2
GETTING READY TO SEW
CONNECTING THE MACHINE
Before plugging in your machine, be sure that the volt-
age and number of cycles indicated on the electrical
data table (1), conform to your electrical power supply.
Plug the controller (2), into the receptacle, at the right
end of the machine.
Then connect the electrical power cord plug (3), to
your electrical outlet.
Do not operate machine without material under the
presser foot as this may damage the feed and the foot.
0 1 !
RUNNING THE MACHINE
The machine and the sewing light are turned on and
off by the same power switch.
POWER SWITCH
Power on-press "1" side of switch. Power off-press "0"
side.
To run the machine, press the speed controller. The
harder you press, the faster the machine will sew.
To stop the machine from sewing, remove pressure
from speed controller.
9