Singer 9920 - Replacing the Exterior Parts; Front Panel (to Front Enclosure); Rear Enclosure

SERVICE MANUAL
9
REPLACING THE EXTERIOR PARTS
K. Front panel (to Front Enclosure)
1. Pass the cords through the openings of front enclo-
sure.
2. Ride the 3 hooks of front panel on the front enclosure.
J. Rear Enclosure
1. Lower the presser foot lifter.
2. Replace the rear enclosure.
3. Retighten the 3 screws (a, b, c).
(Screw-c is longer than others and replace loosely.)
The exterior parts should be replaced in reverse se-
quence when removing. (K. to A.)
TYPE B (Locked by hooks)
3. Push front enclosure around the hook and fit them in
place.
4. Connect the 2 connectors (a: Reverse switch board)
(b: Controller jack assy.)
1 2
4
b
a
3
c
b
a
3
3
TYPE A (Secured by 4 screws)
3. Push front enclosure around the hook and fit them in
place.
Retighten the 4 screws.