THREADING THE MACHINE
Threading _he Needle
Ptace spool of thread on horizontal spool pin. If spool
befng used has a retaining slit, this should be placed
against the spoo! cushion to the right. Select correct
spool holder according to type and diameter of spool
being used. The diameter of the end of the spool holder
shouJd always be larger than that of the spool itself
Press spool hoider firmly against spool
Raise take-up lever to its highest position by turning
the hand wheel toward you: Raise presser foot to re-
lease tension discs. Lead thread from spool holder and
snap it down into guidepost eyeieL Lead thread under
rear thread guide, through the pretension and across
the slot in the top of the machine.
Note: Dotted lines in illustrations represent path of
thread where concealed by machine,
Draw thread firmly into tension disc on right of tension
separator. D_aw thread dewn right channel and up left
ehannet. Thread takewup lever by guiding thread
through slot and into eyetet Lead thread from take-up
lever down through left channel again; _eilow it diagon-
ally to the end then into lower thread guides. Thread
needle from _ront to baek_ drawing about four inches
of thread through eye of needle:
To Next Page
Loading...
