Straight Stitching
To do s_ralgm Stl[cnlng.simply press tne DUttOn uric
IRe SVmDO on toe sTitCh aan@l 5 tea go1 w an-
pear above tne symDoI aria • our machine s _ro
]rammea ro )roauce a oasis _tragnt stitch, suitable
for most straight-stitch reouwernents
Straight-Stitch Plate and Foot
Best for all stratum stacmng. Be sure to use _nese ac
cessorles wnen, our fabric re8 4_res close control They
_reesoec_a , nelEful for stt[cmng dehcate fabrics
When,ouusetne straight-stitch piateor oresserfoot
De sur_ _o set .,our macmne for stralgn_ srl[cmng to
prevent eOSSlDle neeale ereaKage However when you
use me s[ra gnr-srl_cn olaze you get ires exclusive
featulg: f you Dress another burton D_ mistake, you
n3acnlne w st sew a _tralgnt Silica Mistake-proof
stral _ht-stitch selectior
Pattern Repeat Button
The special pattern repeat button on your machine lets
you sew one unit of a pattern such as one tdlip, one
dog, and so on. Simply select desired pattern (such as
the tulip shown here), then a/so press the pattern re-
peat button ( ® symbol). The red light will appear
above the symbol. Press down on controller: Your ma
chine will stitch one unit of the pattern each time You
follow this procedure. You can also use the pattern
repeat button to stitch a series of identical buttonholes,
as descbbed on page 151
Red
Light
CDZ -"_O
:I+
, \
m
One
Tulip
Pattern Pattern
Selector Repeat
Button Button
Single Unit Sewing
Starting to Sew
Position needle in fabric and lower foot: Start machine
by pressing lightly on the speed controller.
Sewing in Reverse
i_ you wish to _einforce the beginning or end of a
seam; touch and h0td the reverse button. Yeu¢ ma _
chine will sew a straight-stitch in reverse foras long as
you hold the button, regardless of the stitch pattern you
have been sewing.
Removing Work from Machine
Raise needle and foot. Draw fabric back to the left. Cut
threads on thread cutter at rear of presser bar, leav:
ing four inches of thread.
Note: Be sure to raise needle out of fabric when ma-
chine is turned off.
Chainstitching
Place bobbin-case insert and chainstitoh plate in
machine. Thread machine in regular manner_ except
pass thread through triangular eyelet in take-up lever,
Set your machine for programmed straight stitching
only - do not press any Other button and do not adjust
stitch width or stitch length.
13
To Next Page
Loading...
